Snapmaker 2.0 3d printing modular holder

thingiverse

Snapmaker 2.0 3D printing holder doubles as a laser module holder, requiring careful consideration of Y-Axis movement when designing for both 3D printing and laser engraving. A crucial factor to keep in mind is the holder's forward shift of 6.30mm on the Y-Axis. **Warning:** If prints shrink or don't meet measurements, some manual filing may be necessary to ensure a proper fit with the holder. Printing recommendations include: * Using support (Recommended: Lines at 10% or less) * Printing in an enclosure (Preferable but not required) Minimum infill ratio for printing is 15%. To secure the Modular on the holder, four M4x8mm Hex Screws are needed, identical to those included with the Snapmaker 2.0. For fixing the lever: 1. One M4x16 flat screw 2. One M4 nut (specifically designed for nuts with a hexagonal shape and a width of 6.90mm)