Snapfit LED holder for Creality CR-10

thingiverse

The CR-10 is designed to print well, but that gets dull after a short while. I suggest stepping up your game: 3D printing in total darkness. This design is intended for use on top bars, but it works perfectly fine on vertical ones - unless you actually turn the printer on and start using it. It features a convenient hole and holder for wires. I strongly advise against using high-powered LEDs, as this model lacks any cooling system whatsoever. Made to fit common Chinese LED panels (40mm x 35mm) The inner snap fit width is 6mm and the outer is 9mm (modeled for stock CR-10 profiles). The print quality in my pictures appears poor, primarily due to poorly set printing settings and has little to do with the model. Dimensions are listed below, in millimeters: Whole model: 50 x 40 x 32 Model without snap fit: 50 x 45 x 7 Maximum LED size: 40 x 35 x 5 (taller will fit but will stick out) This design was made using SolidWorks 2016.