Snap-on wiring guide for Direct Drivinator

thingiverse

Routing Wires with Ease: A Step-by-Step Guide. To avoid wire tangles, follow these straightforward steps: 1. Extend the Extruder Motor Cables by 50cm. - Either add an extension or replace the wires entirely to ensure they reach from one end of the assembly to the other. Then, route them neatly through the braided tube for a clean and organized look. 2. Secure the Wire Guide in Place. - Snap it into position firmly to prevent any movement during use. 3. Position the Extruder with Care. - Move it fully to the right side of its travel range and secure the wires using a ziptie to keep them in place. 4. Test the Wires for Snagging. - Gently move the extruder back and forth, making sure the cables are long enough not to snag on any part of the assembly or reach the Z limit without getting caught.