Snap-Fit Blower 70deg-25mm

thingiverse

Instructions Using the following options: Clearance is adjusted to 0.5 Diameter of fan mount is set to 11 Separation between features is defined as 25 Width of notch is specified at 1.9 Diameter of nut is 7 Length of notch is exactly 10.85 units Bolt diameter for base mount is measured at 5.4 Tip distance is fixed at 25 units Value for cz is 25 units, while value for cy is 25 units Counterbore depth for base bolt is calculated as 10 units Width of tip is precisely 3 Radius of elbow interior curve is established as 0.01 units Outer width measures exactly 15.15 units Diameter of fan bolts is designated at 4.4 Elbow angle is customarily set to 70 degrees Nut height has been fixed at 2 units Height of base bolt is exactly 3 units Tip length has been precisely determined as 40 units Base mount diameter is defined as 20 Number of segments, $fn, has been set to 200 for a precise definition of geometry Offset from notch edge has been carefully calculated at 1 A circle with radius of 22.5 serves as an essential guide. Wall thickness has been deliberately fixed at 1.2 units for overall structure integrity The length of the outer wall is fixed at exactly 20 units to accommodate mounting hardware Offset position relative to center notch is set to 0.91