Snake.... Jointed so it wriggles off the build plate!

myminifactory

Seriously cool snake that comes off the build plate wriggling, ready to slither its way into your collection. Prints really well on a Replicator 2 - just follow the instructions to get it right. First things first, make sure your levelling is spot on and this will almost wriggle its own way off the build plate. Use three shells and a 35% fill at standard resolution for best results (it prints great on a Replicator 2). No support or raft needed, but there's a small amount of manually added support under the fangs to remove after printing. To make your snake look its coolest, try using Z-Pause (at original size) like this: Start with white for two to three layers, then switch to your chosen main colour. Pause at 2mm and change to black for the fang colour. Next, pause at 4mm and change to red for the fang tips. Then, pause again at 5mm and go back to the main snake colour. Finally, pause once more at 9mm and change to your chosen diamond pattern colour.