Snake Charmer II Forearm

grabcad

The old single-shot .410 shorty shotgun in stainless steel that they (apparently) don't make any more needed a forearm, so I modeled up one and will soon be 3D printing it. SO, as of the moment, this model has not been created in the "real" world to be physically checked. I did spend a fair amount of time with the calipers and a radius gage set, so I feel good about the accuracy. I'll let you know when it gets done printing if I have any problems and I'll update the model with any changes required when/if I find any that are necessary.*UPDATE* After printing and finishing, I set about trying to fit it to the barrel. Did not fit! I discovered an error in my measurement (I was in a hurry!) and will update/upload the new tweaks as soon as possible. My error was in the taper of the barrel channel. It does not go fully from end to end! 3/8R to 7/16R from the small end to within 1.6" of the farthest end and then 7/16R from there til the end. My bad!Thanks!