Smooth Murrsuit Thing

thingiverse

- If your planning on using it on someone (that can take this monster) and having it hollow I would recommend firm silicone - if using a cum tube two holes will need to be drilled into mold - The sheath was made big enough to fit the knot through and an elastic on the inner black fabric to seal around the shaft - You could very well just use a strap on harness instead of my holder - My holder is bayonet caped with 3 inch elastic strapping with Velcro together ends - Two cores, one with a cum tube slot and smooth for leds and one textured ________________________________________________________________ - Insert-able length is 296mm (11.7") (without the sheath), Insert-able length is 240mm (9.5") (with the sheath), Shaft Diameter 70mm (2.8"), Knot Width 106mm (4.2") - Mold volume 760 mL ( 26 fluid oz) - Each has a mold and the actual pecker itself depending on how you are going to mold them. - Each side of the mold is in two pieces and will need to be glues together - Mold has location for 5 10mm dowels. - Can be scaled, cut and glued together to any size you want - Use Platinum Cure Silicone, Shore Hardness 10 = firm, 5 = Medium (ish), 3 = soft. - Smooth-On is a good source: "Dragon Skin 10" for firm, "Ecoflex-00-50" for medium and "Ecoflex 00-30" for soft ___________________________________________________________________ - For a quick and dirty toy (will have flashing that needs to be cleaned up) you can use the 3d printed molds - Print with thick walls ex: 4 layers or more with 8% infill ________________________________________________________________ - you can also just print the dick it self, sand it smooth, seal and make a mold the old fashion way, use this way for the best results. ______________________________________________________________ - I recommend printing vertical if possible to get the resolution. - A good resource for silicone toy making: https://vimeo.com/candiru --------------------------------------------------------------------------------------- THE THEORY: - I could design one that would work with a cloth sheath but the sheath would be 50mm then 50mm for knot leaving only 50mm for shaft and head - To take a knot a dildo is limited to 150mm length realistically (My "foxy" design follows this) - So The knot is big enough so the person wearing it can hump hard and it should just slap against the bottom of the other person and not hurt them with too much length and the shaft diameter is big enough to feel like a knot, That is my thinking anyway. - Have Fun!!