Smoke Fountain Incense Burner

cults3d

This incense burner smoke fountain adds not only a pleasant scent to the room, but also creates a captivating visual effect as the smoke flows downwards towards the ground. The design is inspired by the flowing curves of nature and blends elements of both trees and fountains. To achieve this fluid and soft aesthetic, I learned how to create models in virtual reality (VR), specifically for the #POLYMAKERCHALLENGE. The SculptrVR model then underwent refinement in Meshmixer to complete its design. To initiate the spectacle, place a backflow cone over the hole on the top platform and light it. In my experience, the most smoke is released when you remove the lighter a few seconds after smoke appears from the bottom of the cone. Keep in mind that depending on the material used for printing this design, the fountain may melt if the cone burns too low! I printed mine with PLA and had great results, just remember to extinguish the cone slightly earlier so the platform doesn't start melting. I'm unsure why the 3D preview isn't working correctly... I've checked the file in Meshmixer and 3D Builder, and it's fine. (Even downloaded it from Cults and verified the downloaded file.) Perhaps a 35mb file is too large for previewing... I hope you enjoy my creation and don't hesitate to show your appreciation with a like! Greetings from Austria, Your Austrian Maker PS: If you print this file and appreciate it, I'd be thrilled if you could share a picture of your finished product!