Smith & Wesson M&P 15-22 Load Assist Button

prusaprinters

<p>Sliding magazine load assist buttons for the Smith &amp; Wesson M&amp;P 15-22 magazine.</p> <p>This is especially designed for the 10 round pinned magazines from S&amp;W that cannot be disassembled to insert your own follower load assist button. It will work on any 15-22 magazine; however, it is not designed to be removed through the existing hole at the bottom of regular non-pinned magazines.</p> <p>I am currently selling these on eBay, but wanted to make the model available for people to 3D print on their own.</p> <p>Video of installation and use: <a href="https://www.youtube.com/watch?v=YgsyvsHn18k">https://www.youtube.com/watch?v=YgsyvsHn18k</a></p> <h3> Instructions</h3> <p>Included are the STL file used for printing and the original SketchUp file of the model.</p> <ol> <li>Slide the button with axle through the existing hole in the magazine follower. </li> </ol> <ol> <li>Place the magazine with the open axle pointing up on a flat and sturdy surface. Start the button with hole on the axle with your hands so it is finger tight. </li> </ol> <ol> <li>Use a socket to pound the two pieces together. Leave some space between the mag and slider. Do NOT over tighten. </li> </ol> <ol> <li>(Recommended) Use a heat gun or lighter to gently heat the exposed axle. As an alternative, a small drop of super glue can be use to lock the two pieces together. If you choose not to indent the end, you will need to trim the shaft down to fit your receiver. </li> </ol> <ol> <li>(Recommended) Press the heated shaft down like a rivet. Here I used the back end of a drill bit. </li> </ol> <ol> <li>(Recommended) Hold until cool and the plastic will retain the shape. Verify the follower can still slide freely, especially when inserted into the receiver.</li> </ol> Category: Sport & Outdoors