Smith Forefront 2 LED Light Mount

thingiverse

20% infill, gyroid, 3 perimeters, PLA seems sufficient. Remove supports from areas - as shown in attached photo. Careful when removing remaining. Print in orientation as shown and add a wide brim (10?) to promote bed adhesion since it’s a long and skinny print (tends to pull off without brim). UPDATE 10-6-20 V2 offers a slightly higher angle (found my light would self-center too low with previous version). V2 aims light out further..... Several iterations later, I share my helmet mount solution with you all. Designed for an Urban 350 light, probably will fit almost any bar shape light mount with elastic. Feel free to modify. You will also need 1 M5 x 10 pan head bolt.