Smart Garage Case, for Wemos D1 Pro and Dual Relay

prusaprinters

<p>Built this case to hold a Wemos D1 Pro 8266 board, a Dual Relay Board, and a wifi antenna to run a smart garage controller. &nbsp;It is intended to mount on ceiling, and so has holes for #8 screws in the back fr mounting. &nbsp;Large hole is for sensor/control wires coming through the ceiling into the box. &nbsp;Lid will stay on by friction, but for safety have m3 screw holes to clamp it in place.</p><p>Slot next to wemos is for a 3m screw to set in to allow pressing of reset through the case. &nbsp;May need to but a dab of hot glue to fill the hole in the top of the screw, as in my case, it sometimes lines up just right and gets stuck on the button.&nbsp;</p>