Smaller Print Bed - Ferrari 488 GTE/GT3 Rim Body and Top

thingiverse

Everything else needed to complete the rim is available at https://www.thingiverse.com/thing:3400357. This edited body for the Ferrari 488 rim was created here (https://www.thingiverse.com/thing:3400357). The original Body_V2 from that set was too large to print on smaller printing beds, so I split it into three pieces. This will allow you to print a full-size rim; simply replace the Top.stl and Body_V2.stl files from the link above with these five files. The largest piece now measures 198.5mm x 145.6mm x 27mm in dimension. Tolerances are very tight, so you'll need to likely print the pieces and lightly sand them to ensure everything fits together properly. Once you're satisfied with the fit, superglue all mating surfaces together and you should be ready to go.