Small Simple 1U single side shelf

prusaprinters

<p>This is a small 2U-ish sized shelf that is sized and intended for 5 or 8 port ethernet switches or for small embedded computers such as a Jetson Nano in a baseplate or full case. &nbsp;This gives you a good way to mount small-ish devices to your rack in a sane manner without tying up a whole U or more on both sides for something that just doesn't need the width there.<br><br>Print in whatever you want. &nbsp;PLA works so far, but there's nothing keeping you from printing it in PETG/ABS/ASA/etc. other than the load you're going to present to this small shelf. &nbsp;You'll want to print it with the flat of the model to your printbed- it prints nicer and you don't need any supports doing it that way (I know, obvious, right? &nbsp;Well it had to be said for the novices…)<br><br>Depending on application, you may want to use velcro or similar solutions to adhere the thing in question to the shelf proper, but let you remove it easily. &nbsp;This is shown in the application picture where I've installed one of these for my 8-port switch in the rack.</p>