small picture frame - camera body - (3x4,5 cm pictures)

prusaprinters

<p>It is quite a small design made for the "Picture Frame" contest. I wanted to try a little mechanism I designed and play with surface textures a bit. So the handle should look like leather and the mechanism allows the picture to be slipped into the frame and then simply snapped on.</p><p>&nbsp;</p><p><strong>It should fit a 3x4,5cm picture.</strong>&nbsp;</p><p>- <i>It may not be possible to scale up the print much, because if the mechanism become less flexible as it gets larger. I have not tried it, so I do not know when it will become to stiff to work porpaly.</i></p><p>&nbsp;</p><h4><strong>The build</strong></h4><ul><li>It is divided into 3 parts<ul><li>1- The camera</li><li>2- The lens</li><li>3- The screen</li></ul></li><li>The camera (1) and lens (2) need to stuck togheter and are held in place with filament passed through the holes. It should fit tightly. The filament can get cut flat to the surface.</li></ul><figure class="image image-style-align-center image_resized" style="width:75%;"><img src="https://media.prusaprinters.org/media/prints/149878/rich_content/8e803e7b-8184-4bfa-b982-d039bd4989c1/fila-i.png#%7B%22uuid%22%3A%225a8e55ea-197d-4595-abc5-0bdd56509ecc%22%2C%22w%22%3A864%2C%22h%22%3A648%7D"></figure><figure class="image image-style-align-center image_resized" style="width:75%;"><img src="https://media.prusaprinters.org/media/prints/149878/rich_content/31cc589d-cc38-4308-a1a5-113ea9c0adb1/fila-ii.png#%7B%22uuid%22%3A%2242a33f36-c2cc-471c-a114-4db81c8d28cd%22%2C%22w%22%3A1011%2C%22h%22%3A758%7D"></figure><ul><li>The screen (3) snaps into the camera (1) by inserting the round end into the right corner and pushing in the left end. The open part of the screen (3) should face down.</li><li>To get the screen out again, push something (like an allenkey) in the hole on the left.</li></ul><figure class="image image-style-align-center image_resized" style="width:75%;"><img src="https://media.prusaprinters.org/media/prints/149878/rich_content/fb2bf48e-1127-45fe-adf3-84ad42445c62/screen.png#%7B%22uuid%22%3A%220bb1ac31-5a60-476e-9033-f419faa96f0f%22%2C%22w%22%3A624%2C%22h%22%3A468%7D"></figure><ul><li>There are two slots on the back for hanging with flat head pins on a cork board.</li></ul><h4><strong>The print</strong></h4><ul><li>The parts should be oriented in the stl</li><li>I printed the screen (3) with support so I can orient it as in the stl. I did it because you don't see any bridging that way.</li><li><i>my printtime: 5h 56min (layerhight 0.12, without support (exapt for part 3))</i></li></ul><p>&nbsp;</p><p><strong>The best part of designing is to share Ideas and see others enjoy them.</strong> It would be great to see your makes and get some feedback.</p>