Small Parts Organizer for toolbox

prusaprinters

<p>This is a small parts compartments optimized for quick printing and high rigidity.</p> <h3>Print instructions</h3><p>Omit the top and bottom layers to use an infill pattern as the base. The flanges at the top make it structurally efficient while still nesting with adjacent boxes to not waste space. Each took under an hour to print using a .6mm OD nozzle and .3mm layers. The walls are 1.2mm thick so a .4mm nozzle should work just fine printing only perimeters. It fits neatly into the compartments of a Homak cantilever toolbox. Measures approximately 112x40mm (excluding the flanges at the top) but can be scaled if the aspect ratio isn't reduced too much. (If so, supports may be necessary.)</p>