Small-Medium Dog GoPro/Camera Harness-Mount

thingiverse

Small-medium dog Gopro Harness-mount. First print was a little rough but it works out in the end. It was printed using PLA material. https://youtu.be/2NF2mt5l4rg Instructions: First, install the nut to fit snugly around the original GoPro screw. Then get started with a one-inch elastic band or similar product. The dog harness fits nicely on our Jack Russell breed. Watch the video to see that it's strong enough to withstand small bumps against a car but tends to lean slightly to the right. That can be easily fixed, though. The platform was printed on its side with supports underneath the camera mount and the bed. After removing the supports, this made the edge facing downwards feel a bit rough at first. I took the Buckle from Zortrax (http://www.thingiverse.com/thing:348729) and remixed it for use in this harness-mount. Here's what I did: 1. I changed the female buckle end to match up with the male buckle end so that the belt or strap would stay put by friction alone. 2. I eliminated any interior guides to make insertion easier, and I made sure it worked perfectly with one-inch elastic or similar products.