Small Hex Case for SnapGate Tape Measure

thingiverse

Smaller case replacement. Has no space for a lock so keep that in mind. NOT an easy swap, I’d say needle nose pliers and some kind of clamp are required. There is a white disk that holds the spring inside. The hole in the center must be enlarged to fit this case, there was no way to keep the original size without it breaking. The new hole must be at least 8.75mm in diameter. I used a dremel with a cone attachment and shaved off the excess. If handled too much, you may need to replace some of the grease that comes off. Reuses one of the original screws. I’ve added .step files if you want to tinker with it. Enjoy!