Small Garden Seed Storage System

prusaprinters

<p>This is a seed storage system which uses 2"x3" plastic bags cheaply available on Amazon. The bags can be labeled using address labels or hand written. The bags are kept in place by the series of slots built into the model. Multiple bags can be added into each slot or they can be spaced out as desired.</p><p>&nbsp;</p><h4><strong>Print settings:</strong></h4><p><strong>Use a 0.6mm nozzle with a 0.8mm line width.</strong> The walls are 1.6 mm thick, except for the very top which has a width of 0.8mm (single line). Line height can be whatever you desire, I used 0.2mm.</p><p>Please please preview it, make sure there are just two lines along all the vertical walls, except at the very top where it should be a single line.</p><p>The top of the seed box is intended to be printed using <strong>vase mode</strong>. I used 0.75mm line width here to give it a tight fit. Use as many bottom layers as needed to make approximately 1.6mm thick top. This will give a thickness of 1.6mm on all sides.</p><p>The top is a very tight fit, printing at 101% might be a good idea.</p>