Small Funnel with wide mouth

myminifactory

This little funnel has a broad mouth that I use for pouring solid plant food into a one-gallon jug and mixing it with water. I was using a paper funnel that had too small an opening for the clumpy solid, and the paper would get wet and clog and tear when I tried to pour. Now I know you can buy a plastic funnel anywhere for less than it cost me to print it, but where's the fun in that? This funnel is 75mm tall, with a large end that's 75mm in diameter and a small end that's 25mm in diameter. It's only 3mm thick, leaving the large opening at 72mm and the small one at 22mm. I used red PLA because it was already loaded into my printer. I went with standard Cura settings for fine prints and used a nozzle temperature of 200 degrees Celsius and a bed temperature of 60 degrees Celsius. I added a skirt for adhesion and supports for any overhangs, but I don't think the supports were necessary. It took longer to print than I expected at over five hours with these settings. The funnel used about seven meters or twenty-one grams of filament. I think you could tweak the settings and get an acceptable print in a lot less time.