Small 2 Layer Cable Organizer

pinshape

Now that I've got my hands on a 3D printer, I'm realizing my initial Two Layer Cable Organizer was way too big, used up far too much plastic, and took an eternity to print. So I scaled it down, trimmed the fat, cut back on excess material, and squished it into a more reasonable size. The idea behind this design is to create something that can neatly separate power and ethernet cables running under my desk. To tackle this challenge, I came up with a 2-layer cable organizer solution that gets the job done. A large hole at the bottom of each cable section makes mounting a breeze. Printing this one took around 14 minutes, which is a significant improvement over the original's 40-minute print time.