Small 2 Layer Cable Organizer

thingiverse

Having acquired a 3D printer, I discovered that my initial Two Layer Cable Organizer model at http://www.thingiverse.com/thing:7921 was excessively large, wasteful of plastic, and time-consuming to print. To address this issue, I reduced its size by scaling, trimming, and compressing it. My goal was to create a cable organizer that would separate power and ethernet cables running beneath my desk. To facilitate installation, I incorporated a large hole in the bottom of each two-cable section. Printing the revised design took only 14 minutes, as opposed to the original's 40-minute print time. For assembly, simply print several organizers and secure them to your desk before running cables through them.