Slot Car Track Wall/Barrier Bracket - Narrow

thingiverse

This remix of my other bracket is designed to utilize the same 1 1/8" x 1/8" Lattice Moulding, but with a much narrower profile, requiring less filament and significantly reducing print time. I find the Lattice Moulding to be less rigid, allowing it to easily conform to turns without any issues. However, it will not adapt to high-banked turns. This bracket is intentionally designed wide enough to hold two pieces of lattice end-to-end, making it a versatile option. Like the Vinyl, the lattice is readily available at most Lowe's stores and costs approximately $4 per 8ft piece. It can be clipped under the edge of the Carrera 1/24 track at any location except on some areas of lane changer pieces where the bottom is enclosed. A link to the lattice used is provided: https://www.lowes.com/pd/Inteplast-Group-Building-Products-Common-1-8-in-x-1-1-8-in-x-8-ft-Actual-0-125-in-x-1-125-in-x-8-ft-Crystal-White-Polystyrene-Traditional-Lattice-Moulding/50148000 Note: The bracket is intended to be slid onto the lattice from the end, as it's not designed to clip midway.