Slot Car Track Wall/Barrier Bracket

thingiverse

This remix (of my other bracket) is designed to use 1 1/8" x 1/8" Lattice Moulding instead of Vinyl Screen Tight, offering a more flexible alternative that conforms easily to turns without issue. However, it will not bend to accommodate high-banked turns. I intentionally made this bracket wider to enable the use of two pieces of lattice end-to-end. A narrower version of this bracket is in development, designed to minimize media usage and print time. The Lattice Moulding is available at most Lowe's stores for approximately $4 per 8ft piece, similar to Vinyl. It will clip under the edge of the Carrera 1/24 track anywhere except on certain lane changer pieces where the bottom is enclosed. You can find the lattice I used here: https://www.lowes.com/pd/Inteplast-Group-Building-Products-Common-1-8-in-x-1-1-8-in-x-8-ft-Actual-0-125-in-x-1-125-in-x-8-ft-Crystal-White-Polystyrene-Traditional-Lattice-Moulding/50148000 Note: To assemble the bracket, slide it onto the lattice from one end – it is not intended for mid-clipping.