Slot Car Controller Hanger

thingiverse

This is a design created to be attached to the side of a slot car track, typically on the retaining wall or edge of the table, providing an accessible and secure spot to hang a controller by its trigger. Based on the Slot Car Corner design, this concept has undergone minimal changes to accommodate a wider range of controllers. It can be printed without supports on most FDM printers by laying the front face down on the print bed. Additionally, note that in the photos of my holders on my track, I had already cut notches into the walls for my old holders (metal plates attached to the wall). This allowed me to position the printed holders lower, and my track is situated relatively high. The printed design is intended for the holder to be mounted higher up, with sufficient clearance for most triggers to avoid hitting the top of your wall or table, which is why the countersunk screw holes are located at the bottom.