Slot Bracket for Gotek board

prusaprinters

This is a PC slot bracket that holds a Gotek floppy drive emulator in place at the back of a PC case.Bill of MaterialsThis print, of courseGotek board3x Self-tapping screws for plastic, lens head, 3.0 x 8Printing and AssemblyI used PLA, and printed with a resolution of 0.2mm, without rafts and without supports. For better stability, I recommend to use 100% infill.The LED must be bent into the new position. Take care not to short-circuit the legs of the LED! If you don't need the LED, there is an alternative version without LED hole available too.There is no space for the 7-segment display, as it doesn't make much sense on the back of a PC. It's better to find a way to mount the display (or an OLED display) to the PC front.