Slip case for universal phone/tablet stand

thingiverse

Early this year I printed ClassicGod's Universal Phone/Tablet stand. In [my make of that Thing](https://www.thingiverse.com/make:320420), I showed that I'd also designed a slipcase to hold the stand when not in use, so it would not unfold while in a pocket or whatever. However, I got distracted and forgot to post the model. Here is the most recent iteration of the slipcase. Note that the case is intended for use with a stand that has thin craft foam glued to the bottom (as mine has). The tolerance on my original print was a little bit tight, but it did work. This more recent version has not yet been printed for testing and I haven't worked on it in over a year, so I'm uncertain how much - or even if - I fixed it. The tolerance might be too loose, just right, or not changed at all. I would recommend not shoving the stand all the way into the case until you are sure it isn't too tight to get it back out again. If the fit is too loose, you might wish to print the optional cap or use a rubber band around the long axis.