Slinky Remix

thingiverse

I redrew the slinky in Fusion 360 using Desktop_Makes measurements but I reduced the .6mm gap between the layers to .2mm. That gave it a much cleaner appearance on the under side of each layer. There still was some stringing as it printed each layer on the inside of the circle, but it was reduced significantly and was removed easily when it was completed. I did it before I separated the layers. It sill came apart very easily. I used an Xacto knife but a putty knife would have worked just fine. I used 20% infill but that was actually by mistake.100% would probably be better. And it does work. I had it walk down a couple of boxes that I stacked up. It's a great design thanks Desktop_Makes