Slinky

cults3d

Big Slinky, probably capable of walking down the Stairs, but such stairs were not found yet:) Name V17 says a lot:) Slinky with diameter of 90mm and height of 100mm and 50 rings. It is very nice, problem is just to separate the rings. Try a height of 10mm (Model for height 10mm is also in the attachments ) and try to separate the rings and then you are ready to print a height of 100mm. Between rings is just 0,25mm of air. Hard to separate but nice to look. Separation: First use Needle-noise pliers and with movement make place between two rings where you insert Olfa-knife and go with the knife over whole length. Probably slinky should walk down the stairs, but the stairs were not found yet:) I would say the maximal length of the Stair should be cca 150mm. https://www.youtube.com/watch?v=9IojLxKbob4&ab_channel=RokJene https://www.youtube.com/watch?v=Ba2qAZi-ZqI&ab_channel=RokJene