Slimline Compact dual twin 30mm fan shroud for e3d v6

thingiverse

Further Update: The latest fan shroud by Jinx now includes adjustable height for the print fan sides, making it easier to customize your setup. One version comes with holes to mount a DC42 IR sensor, taking your printing capabilities to the next level. UPDATE: Innovation is happening fast; Jinx of the Reprap community has already remixed this version and made significant improvements. He has replaced the cable tie with a bolt for better stability and ensured that the hot end fan mounting face is flush with the part cooling fan bases, simplifying printing. This is an ultra-compact remix of the fan holder by saldot, designed specifically to fit an e3d v6 while accommodating almost under my Kossel effector. The original design was too wide for my setup, cutting into the print volume and interfering with the belts when moving closer to the edge of the bed. This version has been optimized to be as small as possible without compromising the geometry. To secure the hot end cooler shroud in place, use a cable tie on the opposite side of the fans, ensuring a snug fit. The screw holes for the fans may require some persuasion to align properly when printing, but they should go in smoothly with a little effort. Achieving the right orientation of the heater block relative to the shroud can be challenging, but there are several angles that work. Print Settings Supports: Yes Notes: I printed it as shown here with plenty of support. I may try creating a version with a flatter side to reduce the need for support structures. Design Process Using tinkercad and drawing inspiration from http://www.thingiverse.com/thing:1676276, I designed this fan shroud to meet your specific needs.