Slim double fans for Zortrax M200

thingiverse

In my case, big prints covering the whole build plate caused problems for the original fan design because it was hitting the bed connector. To solve that problem, this version of dual fans reduces height by 3.2mm and works without any issues. On December 24, 2015, I added a taller version of this model, increasing its height by 2mm. However, even in my case, this revised design doesn't touch the bed connector at all. Here are some key settings that were used during printing: Printer Used: Zortrax M200 Additional Settings Raft was used, Yes Supports, Yes Layer Resolution is 0.29mm and The print had full infill. Notes This object requires support with light setting of ten degrees. You should stick to the stl file for placement.