Sliger SM560 Vertical Stand

thingiverse

These are version 2 files, I've increased the size of the posts on the interior for more rigidity and slightly reduced the size of the opening in the rear for more rigidity there too. I also slightly lowered the skirt in the back since you won't see it and it should let you keep the case feet mounted rather than having to unscrew them. Just a basic skirt for the Sliger SM560 so you can stand it up vertically. The height is the minimum I've found that allows dongles and large displayport connectors to have enough room. Note: this is set to give 1mm of total clearance on the width and height (.5mm per side) for a nice, clean look. I have 3 SM560s and measured all of them and Sliger's published height of 208mm is right on, but all 3 of my cases are 155.5mm wide instead of the published 159mm. I know of another case that's 157mm wide at its widest, so I've included another 157mm wide .stl file in case you need a slightly wider one. Ideally it's a nice snug fit so you don't have gaps around the base.