Sliding Door Offset Catch

prusaprinters

<p>Needed a convenient way to keep the sliding door hard up against the pet door insert.</p> <p>This isn't a security thing, it just stops the door from sliding back a little letting the cold breeze in.</p> <p>For security we have a security screen we can close over the door, a lump of timber behind the door to stop it sliding, or we just take the pet door out and close up properly.</p> <p>DO NOT rely on this item to secure your house.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>CR-10S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>200</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20</p></div> <p><strong>Filament:</strong> Esun PETG Magenta</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Minimal supports on the front piece, no supports anywhere else.</p></div> Post-Printing ============= <p>You may need to file a little to get the two halves to fit together, I luckily did not, this is the first time I used PrusaSlicer and I'm super happy with it.</p> <p>You'll need some 1.7mm filament to insert in the pin and a 25 mm m4 bolt and washer, it's designed to take a M4X6X6 brass insert but I've not needed it so far gravity and friction hold the bolt in.</p> <p>You'll also need a rubber band to go through the hole in the bottom of the loop handle and over the top of the catch in the v-groove.</p> </p></p></p> Category: Other