Slide-under door-stopper

thingiverse

A design I faintly remember being at my house at my early days, you slide the doorstop under the door - this makes the door drag the stopper with it when it's moving. Push with your leg from the cube side while closing a room. kick from the other side to make the door hold it's position. if you already have a stopper of the clamper type, you could lift the door and slide it under it so it secures it in place rather than interfering. bridge height adjusted to 2mm, my floor is elevated with vinyl so this may need a tweak. the angle for the stopper triangle was taken from a normal triangle stopper I've found in my room, figured the height, and added some clearance which may not be enough in your room in case the floor-to-door height is above approx ~7.5mm. I made this while my robot cleaner inspired me to do so, as it was kicking the other stopper every time, with this design I assume it could work better as it protrudes less from the door area Note: Make sure to check the clearances to ensure the piece would work straight off the printer without further modifications, otherwise the base piece might need to be elevated to compensate for the height lost in my case due to vinyl floor Updated the new model to have a slope from the base so it would fit most doors. also added the f3d file for you to tweak according to your distances/height requirements.