Slide-on-door doorstop (parametric)

prusaprinters

This little doorstop simply slides under the side of your door, if you get the parameters right for you door it should lock its position. The ends of the doorstop are slightly angled down to apply more force, to insert the doorstop push the center in and slide it under the door. I recommend not taking the angle of the ends into account when measuring and to simply measure the gap between the floor and your door. Adapt the “door_gap_height” parameter accordingly and only after this you can tweak how much additional force you need with the “ends_angle” parameter. A somewhat flexible material like petg is ideal for this model.The model contains two hexagon holes, they can be used for hanging the doorstop when not in use or you can design a plug for them to put any decoration on your doorstop that you may please. You could also fit HSW designs into these since the holes are parametric. They could even be used as screw holes to bolt the doorstop to the ground if that is an option/wished.