Sleeve Case for ODROID C2/C1+

thingiverse

This case is designed for the ODROID C2 and should also fit the C1+, although I don't have a C1+ to test. My design is based on walter's simple and elegant design, with some of my own touches added in. The C2's included heatsink and bottom side components make it a bit bulkier, so I can't promise that it will clear an eMMC module - again, no eMMC module to test with. To print this case, you'll need the following settings: - Printer: 3KU Delta - Rafts: No - Supports: No - Resolution: 0.2 mm Important notes: You may want to cut out support for the SD card slot; I'm not entirely sure if it's necessary, but it's better safe than sorry. After printing, be aware that there is a bit of Z wavyness due to an off-center stepper pulley.