Sledgefire 17/32 Brass Barrel - Single Half Dart Hand Cannon

thingiverse

Shell: Converts the Nerf Sledgefire to fire 1 half length dart through a 17/32 brass barrel. Seems to deactivate the air restrictors well enough without needing removal. The brass barrel must be epoxied into place inside the shell. I also added a small amount of epoxy to the shell part where the supports once were. - See photos edit: During testing I found this shell to hit an average of 118 FPS using Adventure Force Pro darts. ** Print this shell upside down with supports, sorry! A better seal between the plunger and shell will be needed in order to not leak air. It is also essential to remove the shell ejector so that this part stays in place. The last two photos are the parts of the ejector that must be removed. Note: retain small spring and L shaped tooth and replace exactly as they were. This will prevent the shell from becoming misaligned or falling backwards during operation. Void Fill: Needs a small piece of electrical tape on the flat, rear most section to eliminate play. Fills the area where the Sledgefire stock once was. See photo. **Print flat part down with supports. Front: Friction fits into the front end of the Sledgefire. Keeps the Brass barrel aligned nicely. See photo.