sled and reindeer and gifts for christmas

pinshape

I've created an amazing Christmas decoration that sits atop my chimney, securely fastened with double-sided tape. A beautifully crafted sled is adorned with presents inside and reindeer pulling a hitch. The sled measures 15 cm wide, 8.3 cm long, and 8 mm thick, while the reindeer measures 13 cm wide, 15 cm long, and 5 mm thick. The bow of the gifts is a delicate 2 cm by 2 cm, with a thickness of 4 mm, and without the knot, the gifts measure 3.3 cm by 3.5 cm, also with a thickness of 4 mm. I added a city below the sledge, measuring 19 cm in length, 12 cm in width, and 2 cm thick. I wish you a stunning Christmas decoration and all my heartfelt wishes for happiness, joy, and gifts during these holiday seasons. The 3D printing parameters I used include a filling rate of 30% and an extrusion speed of 80%. The temperature was set to PLA at 215°C, with natural PLA visible in the photo. The layer thickness is 0.2 mm, shell thickness is 0.8 mm, and no support structures were required. The printing times for each component are as follows: reindeer (1 hour 3 minutes), sled (1 hour 22 minutes), bow of gifts (4 minutes), gifts without the knot (8 minutes), and city (1 hour).