sled and reindeer and gifts for christmas

thingiverse

I envisioned a Christmas decoration that I placed atop my chimney, secured with double-sided paste to ensure stability. A sled with gifts inside and reindeer pulling the hitch was carefully crafted. The sled measured 15 cm in width, 8.3 cm in length, and 8 mm in thickness. The reindeer stood at 13 cm wide, 15 cm long, and 5 mm thick. A bow on top of the gifts measured 2 cm by 2 cm with a thickness of 4 mm. The gifts themselves measured 3.3 cm by 3.5 cm by 4 mm in thickness. Below the sled, I added a cityscape measuring 19 cm in length, 12 cm in width, and 2 cm in thickness. Three such cities were placed below the sledge on my Christmas decoration. Wishing you a beautiful and joyful Christmas decoration filled with happiness, joy, and gifts during these festive holidays. 3D Printing Parameters: - Filling rate: 30% - Printing speed: 80% - Material: PLA at 215°C - Thicknesses above 0.2 mm - Layer thickness: 0.2 mm - Shell thickness: 0.8 mm - No support required Printing times for each component: - Reindeer: 1 hour and 3 minutes - Sled: 1 hour and 22 minutes - Bow of gifts: 4 minutes - Gifts without the knot: 8 minutes - City: 1 hour