Slammed Shendrone Squirt v2 Mini Ducts - GoPro 5/6/7 Mount v2 - Caddx Vista - Nebula Pro Antenna Mount

thingiverse

I remixed a few files that DroneCOproductions created for the Shendrone Squirt v2 (https://www.thingiverse.com/thing:4729661). Here is more detail on my Squirt Build: https://rotorbuilds.com/build/27601 A quick breakdown about the files I remixed. Antenna mount in the rear of the quad (SQUIRT_VISTA__ANTENNA_MOUNT_v2.stl). If you mount the caddx vista at the very end of the squirt v2 frame with the existing M2 20x20 holes, the Caddx Air Unit sits very close to the rear standoff. It is so close that there is no room for the antenna mount to slide far enough down for ducts to stack on top of. So, I remixed it by cutting a 3mm notch to allow it to slide down a little further. Next up are the ducts (MiniDucts_Slammed_v5.stl). The hole where the 25mm standoff goes through in the front is too thick. It is fine until I put the carbon fiber top plate on. So, I removed 2mm off two holes that goes in the 25mm standoff. Finially, the GoPro 7 case (Squirt GP 7 Full Mount v01.stl). The GoPro mount that DroneCOproductions created did not have enough protection for my taste so I used my favorite case and remixed it to fit this build. I am willing to take on the extra weight to give the GoPro 7 more protection. (side note: I forgot to rotate the gopro model before creating the STL file. I usually print with the lens side facing up.)