Slack Lack Resized

thingiverse

Update 2020-11-23 The top spacers have been fixed as they were all uploaded with a +30mm extension. There are now two options available: one with and one without the extra 30mm. Instructions for assembly can be found in the original design, along with any non-resized parts. Update 2020-07-25 Some top catches with magnet holes have been added for alternative or double latching. Update 2020-07-19 Tracks have been reduced by 1mm to support a slightly slimmer gap achieved by centering the holes for the legs. My plexi has arrived and fits tightly, but it's essential to measure yourself as you build due to print expansion and margins for error in cutting. Measurements are: * Main Panels: 446mm x 524mm * Door Panels: 213mm x 524mm Other objects used in my enclosure include: * Cable clips from https://www.thingiverse.com/thing:2864118 * Angled light reflectors (making sure not to install them in the path of the doors!) from https://www.thingiverse.com/thing:3596318 * Filament guide from https://www.thingiverse.com/thing:2137546 * Spool holder from https://www.thingiverse.com/thing:2451368 * Rear cable pocket from https://www.thingiverse.com/thing:3624551 I consider this remix complete, but I'm thinking of adding spacers to seal the side of the doors. Update 2020-06-25 A new piece has been added - the CatchSpacer. Instead of using a hole spacer, you can use this to position catches if temporary gluing is involved. Update 2020-06-24 The hole finder has been adjusted to accept an extra 2mm spacing and reuse pre-existing holes in the Lack. My plexi is on order, so I'm hoping to get it soon and confirm sizes plus door spacing next month (due to supply delays). Update 2020-06-10 Some changes are likely now that I've played around with the Lacks. They have an additional 2mm margin between table edge and legs when positioned using pre-drilled leg<->table holes, so depending on whether I put these legs flush with the outside of the table or with overhang, they'll need adjusted (or hole guide). I'll decide once all fixings are in and I can have a further play. It's not a priority either way. ================ A few tweaks to the Slack Rack and an enhancement: * Resized all legs to match 50x50mm of the legs * Added a 2mm fillet to vertical corners of the legs to match IKEA versions * Added a 1.5mm fillet to side pieces that screw into legs at front top for consistency with back top pieces * Moved holes in spacers to be central to legs so existing holes can be reused, and adapted hole finder accordingly * + Added additional top spacer versions with an added 30mm of height. This should give a total height of 53cm internal to the enclosure.