Skådis caliper holder (1 part print, no supports!)

prusaprinters

I've printed another Skådis caliper holder, but I got frustrated that nearly every time I lifted the caliper off, the holder came off the hook, so I set about coming up with a single part print. I used the same angles as in the pliers holder by Ivan Urbánek.This should be printed upside down, with the slanted top face on the print bed. You'll need a clean bed and good adhesion to stop it from falling over during printing.I printed it in Jessie PLA but it should work in other materials. It might be a little tight for materials that shrink more.