Skyzone SKY 04X Pro Walksnail Hdzero VRX Mount

thingiverse

This model is a VRX mount for the Skyzone Sky 04X Pro FPV goggles. I had downloaded a similar mount intended for older Skyzone goggles and when it didn't fit I decided to model my own.NOTE: this mount requires that you replace the screws on your goggle's fan mount with longer replacements ordered online. Like other 3d printed vrx mounts, this attaches under the fan mount. This one has been modeled to perfectly fit the Skyzone Sky 04X Pro goggles, and allow the original fan cover to be screwed back down over it, resulting in a relatively "stock" or stealth appearance. Because this mount raises the height of the fan cover, longer screws are required. I used 1/2" Number 0 Size metal/plastic screws from McMaster-Carr. Their product number for these screws is 90065A028 and the followng URL should take you to them: https://www.mcmaster.com/catalog/130/3406/90065A028 . As you can see from the photo, when installed, they look identical to the original screws. To install this mount as pictured:Unscrew the 4 screws holding down the fan cover and remove it.Slightly lift the fan, until it comes off the 4 mounting pegs. Don't pull the fan too hard or too high, as its connections are delicate.Depending on how the fan wires are routed in your goggles, you may need to cut this mount so that the wires may pass through the large circular area.Put this mount under the fan and slip it down over the 4 mounting pegs.Put the fan back in place, by slipping it down over the 4 mounting pegs.Reinstall the fan cover with the longer screws.Also: I don't actually own an HDZero system, but I think they use the same mount as Walksnail. If someone could comment and confirm, that would be great!