Skytank 210 / QAV 210 rear xt60 mount with TX pigtail mount with RX tie wrap mount and holes for rx wires

thingiverse

Created a Skytank 210 rear xt60 cable adapter with TX pigtail cutout and an RX tie wrap with pass-through holes for the RX wires to run along the tie wrap. This should be an all-in-one solution for the rear end. Note: You might need to sand out the TX mount, as I used hard material for the 3D print and had to sand it myself. Alternatively, you could use a softer material for the print and avoid this issue altogether.