Skyrim logo necklace

thingiverse

A Skyrim Logo Necklace! Original model by: https://www.thingiverse.com/thing:3042456 I basically adapted it to a simple necklace, thicker, added proper support, an attachment point etc... Printing! I included my supported STL's as well as the sliced files for the Anycubic Photon S. My Print Settings: (in use in the pre-sliced file) Printer: Anycubic Photon S What to print?: 4 double-sided Skyrim necklaces at once Time to print?: around 8 hours Layer height: 0.02 mm Quantity of resin used: around 20 mL Type of resin: Anycubic Eco plant-based resin (macaroon pink and blue) Printing temp: around 20C, the highest I could get at the time Washing, Curing! I recommend removing supports before curing. It's a bit more tedious with gloves and a mask, but they come off easier and there is less risk of damage. Also recommending to cure underwater, just tried with the last batch and they came out great. Sanding! I started with 100 grit, then 150, 250, 600 grit. Basically sand supports marks until they are flat, then increase grit for a smooth finish. Painting! I did two thin layers of black primer, then two layers of shiny chrome, short. /!\ WARNING /!\ I left the first three ones I printed on my desk in the sun before painting and they started to warp after 2-3 days. So maybe avoid leaving them in the sun before painting. (or cure them more). Have fun :).