Skycontroller ON/OFF Switch (for Bebop Drone)

thingiverse

Fell and lost it on the first day, however. 4 iterations to get back on track. As always, check the output of your slicer before proceeding. Print with supports, refer to the picture for orientation. Approximately 20-24 minutes total print time. Installation: Note the asymmetry of the part, take note of the current position of the black pin switch (in the sky controller) and align accordingly. Insertion requires significant force and care. Press on the peg or very close to it only, as excessive pressure may cause edge breakage if layer adhesion is poor. If properly installed, it will not fall out and still fit in the box.