SKR1.3 board electronics enclosure

thingiverse

Keep your electronics in a secure and organized space with this modular enclosure. It features all the areas you're most likely to use pre-cut, so you can access them without having to take out panels. The top of the enclosure has a single opening for a 60mm fan blowing into the enclosure; make sure the smaller side panel with the vent holes is positioned on the opposite end from the fan as shown in the images to maximize airflow over the board. Electronics connectors - This enclosure uses standard aviation plug types, and the larger 15mm holes are designed specifically for the heater bed and hot-end since they require a higher amperage. The smaller 12mm holes are intended for your motors, sensors, and auxiliary equipment. The bottom of the case has four 3mm holes with the option to enlarge them using a drill if you prefer. I recommend constructing the case using self-tapping screws or bolts. I've personally used high-pitch thread Torx fittings and found that they grip well into the lugs on the inside.