SKR1.3 board electronics enclosure

cults3d

Keep you electronics in a secure and neat environment with this modular enclosure. It has all the areas you are most likely to use cut-out so you can access them without having to remove panels. The top of the enclosure features a single opening for a 60mm fan blowing into the enclosure, please ensure the smaller side panel with the vent holes is located at the opposite end to the fan as in the images to maximise the airflow over the board. Electronics connectors - This enclosure uses the standard aviation plug type, the larger 15mm holes are for the heater bed and hot-end as they take a larger amperage and the smaller 12mm holes are for your motors, sensors and auxiliary equipment. The bottom of the case features 4 3mm holes with the option for you to enlarge them with a drill if you wish. The method of construction of the case I'd suggest using self tapping screws/bolts. I've used high pitch thread torx fittings and they grip into the lugs on the inside very well.