SKR V1.3 & TFT35 V2.0 Case (MPCNC)

thingiverse

I sought out cases for my MPCNC and new SKR 1.3 with TFT35 V2.0, and although there were a few options available, they did not meet my needs. I designed this case to meet the following requirements: * Access to the microSD card & USB port on the SKR 1.3 as well as the SD card on the TFT35 V2.0 * Good airflow over the stepper motors (fan) * Minimal holes in the case, as I plan to use it with a CNC and there's a lot of dust to worry about * Ability to flip the display/angle without much hassle. With the latest firmware, you can simply flip the lid of the box and then rotate the display, which will have an angle upward if mounted on the front rather than flat * It should fit a 40x10 fan (no screws; held in place by side rails and a top block) * It should accommodate a female [5.5MM x 2.1MM DC plug](https://amzn.to/2C1dTHE), which runs power in. If you don't need this, you can just run the power wires through the hole or edit the Fusion 360 file to change it to suit your needs. For my current setup, I use the flip case mounted vertically, so I need the display to be angled upward. In the future, I plan to move and mount it horizontally, so I'll simply flip the top. This case is designed to allow you to flip it without changing any components. To keep everything in place: * M3 screws hold the SKR 1.3 down. I installed [brass inserts](https://amzn.to/2NxZGY5), but they should also self-tap the screws if needed * To hold the lid on, use M3 screws and brass inserts * To secure the TFT, M3 screws come in from the top and are held to the TFT35 via a nut I've included the Fusion 360 file so you can feel free to edit it to suit your needs. For the MPCNC, I had to create my own firmware to get everything running: * Check out the build on the [V1 Engineering forum](https://www.v1engineering.com/forum/topic/mpcnc-build-complete-until-my-next-good-idea/) * Get the firmware for the MPCNC with dual end stops on SKR 1.3 at: https://github.com/BlomsD/MPCNC-SKR1.3-TMC2208UART * Get the firmware and graphics for the TFT35 V2.0 at: https://github.com/BlomsD/MPCNC-TFT35-V2.0