SKR Pro 1.1 Case

thingiverse

This case accommodates an SKR Pro 1.1. Please note that discrepancies in the boards I've measured indicate that the mount holes may be slightly off for your board. Additionally, one of the tops utilizes a cooling tunnel designed by raabi91, which can be found at https://www.thingiverse.com/thing:3747006. UPDATE: A new top has been added that incorporates aviation connectors to the front panel. I disliked pulling motor wires in and out of the board since the connectors tend to be flimsy, so I switched to aviation connectors and love it. The connectors used are available at https://www.amazon.com/gp/product/B07D7SHKGK/ref=ppx_yo_dt_b_asin_title_o02_s01?ie=UTF8&psc=1. This case has been printed and tested, with all components fitting together as expected. This case is split into two pieces (top and bottom). The two are joined using M3 hardware. I have recessed slots inside the case to hold M3 nuts. Nylock nuts are used, along with a dab of superglue to ensure they stay in place for easier mounting. If requested, I will release a version without the cooling tunnel and instead include mounting spots for an 80mm fan on the top. Due to the sd card only being used to store firmware on these boards, the card slot is not very large. If you need to remove it, you can use something to push it in from behind and help it pop out. Another consideration I have been thinking about is cooling for the bottom of the board due to heatsink mounts for certain components being bottom mounted. If anyone experiences any heat issues with the SMDs on the board itself, please let me know.