SKR 1.4 Turbo mount for CR10

prusaprinters

Adapter mount to allow theSKR 1.4 to be mounted on theoriginal CR10 mounting bosses. I wanted stronger fan mount and better bosses for the screws to go into for the board, than other designs I tried. There are two holes for a couple of M3 plastic spacers to be screwed into to provide support for the hanging end of the mount, minimising the floppiness was seeing on another version that I downloaded. You don't have to use them, but it helps when pushing connectors into the board to prevent the adapter plate from flexing. Using this mount you can cut one simple rectangular hole into the side panel of the CR10 case using a Dremel circular cutting disk, allowing the SD card and USB ports to be used in a similar way to the original CR10 board. I created a bezel to provide a tidy finish to this hole and make for an easy hole cut with a bit more forgiving tolerance than trying to cut holes for each. Bezel design https://www.thingiverse.com/thing:4392864 Category: 3D Printer Parts